EDP Sciences logo
Submit your research paper
Search
Menu
All issues J. Eur. Opt. Soc.-Rapid Publ., 9 (2014) 14004 Article references

Articles citing this article

The Citing articles tool gives a list of articles citing the current article.
The citing articles come from EDP Sciences database, as well as other publishers participating in CrossRef Cited-by Linking Program. You can set up your personal account to receive an email alert each time this article is cited by a new article (see the menu on the right-hand side of the abstract page).

Cited article:

Surface roughness control in deep engraving of fused silica using femtosecond laser ablation

Evaldas Kažukauskas, Simas Butkus, Vytautas Jukna and Domas Paipulas
Surfaces and Interfaces 50 104471 (2024)
https://doi.org/10.1016/j.surfin.2024.104471

Influence of dwell time and temperature on the measured gloss of printed UV-inks containing aluminum pigments

Carl Fridolin Weber, Ilayda Polat, Hans Martin Sauer, Edgar Dörsam and Martin Schmitt-Lewen
Journal of Coatings Technology and Research 21 (1) 281 (2024)
https://doi.org/10.1007/s11998-023-00820-4

Scanning Algorithm Optimization for Achieving Low-Roughness Surfaces Using Ultrashort Laser Pulses: A Comparative Study

Evaldas Kažukauskas, Simas Butkus, Vytautas Jukna, Domas Paipulas and Valdas Sirutkaitis
Materials 16 (7) 2788 (2023)
https://doi.org/10.3390/ma16072788

Effect of Surface Roughness on the Surface Texturing of 316 l Stainless Steel by Nanosecond Pulsed Laser

A. Al-Mahdy, H. R. Kotadia, M. C. Sharp, et al.
Lasers in Manufacturing and Materials Processing 10 (1) 141 (2023)
https://doi.org/10.1007/s40516-022-00199-x

Investigation of NS-single-point laser ablation of bronze under different incidence angles and pulses

Esmaeil Ghadiri Zahrani and Bahman Azarhoushang
Journal of Laser Applications 35 (4) (2023)
https://doi.org/10.2351/7.0001146

Femtosecond pulsed laser ablation for paint removal at oblique illumination: Effect of the incidence angle

Alicia Moreno, Ana J. López, Javier Lamas and Alberto Ramil
Optik 264 169428 (2022)
https://doi.org/10.1016/j.ijleo.2022.169428

Influence of test parameters on the cyclic oxidation behavior of AISI 310 and a new Fe-5.9Si-3.9Cr-4.5Ni-0.8C (wt.%) alloy

João Gabriel da Cruz Passos, Daniele Silva, Robson Bruno Dutra Pereira and Artur Mariano de Sousa Malafaia
Matéria (Rio de Janeiro) 27 (3) (2022)
https://doi.org/10.1590/1517-7076-rmat-2022-0002

Nanosecond laser-assisted micro-scribing of a copper film on a dielectric material with laser-induced breakdown spectroscopy based monitoring

Sooraj Shiby and Nilesh J. Vasa
Optics & Laser Technology 147 107685 (2022)
https://doi.org/10.1016/j.optlastec.2021.107685

Tailored absorptivity: Increasing the laser weldability of copper through surface structuring

Robert Baumann, Dominik Hipp, Andrés Fabián Lasagni and Achim Mahrle
Materials Letters 283 128700 (2021)
https://doi.org/10.1016/j.matlet.2020.128700

Hole annihilation vs. induced convection: Breakdown of different contributions to the photocorrosion mechanism of oxide-covered iron

Håvard Wilson, Svein Sunde and Andreas Erbe
Corrosion Science 185 109426 (2021)
https://doi.org/10.1016/j.corsci.2021.109426

Effect of surface roughness on the ultrashort pulsed laser ablation fluence threshold of zinc and steel

H. Mustafa, M. Mezera, D.T.A. Matthews and G.R.B.E. Römer
Applied Surface Science 488 10 (2019)
https://doi.org/10.1016/j.apsusc.2019.05.066

Relation between emissivity evolution during annealing and selective oxidation of TRIP steel

Shu Hui Ham, Cédric Carteret, Jesus Angulo and Gabriel Fricout
Corrosion Science 132 185 (2018)
https://doi.org/10.1016/j.corsci.2017.12.032

Spectroscopic ellipsometry and X-ray photoelectron comparative studies of tribofilms formed on cast iron surfaces

M.L. Miranda-Medina, S. Spiller, A. Vernes and M. Jech
Tribology International 113 101 (2017)
https://doi.org/10.1016/j.triboint.2016.12.021

Quantifying the Pathway and Predicting Spontaneous Emulsification during Material Exchange in a Two Phase Liquid System

Stephen Spooner, Alireza Rahnama, Jason M. Warnett, et al.
Scientific Reports 7 (1) (2017)
https://doi.org/10.1038/s41598-017-14638-9

IR radiometer sensitivity and accuracy improvement by eliminating spurious radiation for emissivity measurements on highly specular samples in the 2–25 μm spectral range

T. Echániz, R.B. Pérez-Sáez and M.J. Tello
Measurement 110 22 (2017)
https://doi.org/10.1016/j.measurement.2017.06.010

A comprehensive study of infrared reflectivity of poly(3,4-ethylenedioxythiophene) model layers with different morphologies and conductivities

Charlotte Louet, Sophie Cantin, Jean-Paul Dudon, et al.
Solar Energy Materials and Solar Cells 143 141 (2015)
https://doi.org/10.1016/j.solmat.2015.06.047

Modelling and experiment of selective oxidation and nitridation of binary model alloys at 700 °C – The systems Fe, 1 wt.%{Al, Cr, Mn, Si}

M. Auinger, E.-M. Müller-Lorenz and M. Rohwerder
Corrosion Science 90 503 (2015)
https://doi.org/10.1016/j.corsci.2014.06.049

Grain boundary oxidation in iron-based alloys, investigated by 18O enriched water vapour – The effect of mixed oxides in binary and ternary Fe–{Al, Cr, Mn, Si} systems

Michael Auinger, Vera G. Praig, Bernhard Linder and Herbert Danninger
Corrosion Science 96 133 (2015)
https://doi.org/10.1016/j.corsci.2015.04.009

Sequential Growth of Zinc Oxide Nanorod Arrays at Room Temperature via a Corrosion Process: Application in Visible Light Photocatalysis

Danish Iqbal, Aleksander Kostka, Asif Bashir, et al.
ACS Applied Materials & Interfaces 6 (21) 18728 (2014)
https://doi.org/10.1021/am504299v

Pulsed photothermal mirror technique: characterization of opaque materials

O. A. Capeloto, G. V. B. Lukasievicz, V. S. Zanuto, et al.
Applied Optics 53 (33) 7985 (2014)
https://doi.org/10.1364/AO.53.007985