| Issue |
J. Eur. Opt. Soc.-Rapid Publ.
Volume 6, 2011
|
|
|---|---|---|
| Article Number | 11050 | |
| Number of page(s) | 4 | |
| DOI | https://doi.org/10.2971/jeos.2011.11050 | |
| Published online | 18 November 2011 | |
Regular papers
Mould fabrication for polymer optics
Aalen University, Centre for optical technologies, Aalen, 73430, Germany
Received:
29
July
2011
This work is focused on the process chain for mould fabrication for the injection moulding of optical components. To achieve a good form and surface quality on steel moulds is the intention; the new process chain should consist of just 3 steps instead of 5; nickel plating and diamond turning are superseded. Manual polishing is replaced by robot polishing.
Key words: steel polishing / mould fabrication / polymer optics / robot polishing
© The Author(s) 2011. All rights reserved.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.